The “PDS series multi-angle tension detector " uses steel as the backbone of the mechanism, which can withstand stress for a long time and keep the mechanism from deforming.
The detector is mounted on the shaft end of the roller to convert the material load into an electrical signal for surface tension detection.
•
The design of the round cake shape allows the tension detector to be installed in a wide angle range.
•
The structure of the mother and daughter axles can reduce the friction of the rollers and is suitable for occasions with low tension requirements.
•
The tension detector with high sensitivity and temperature compensation circuit makes the linear error of tension detection low.
•
Amplifier design option available, which can direct interchange with LMS series tension detectors.
PDS-3025
PDSA-3025
Tension Detector PDS series Specification -1
Model No.
PDS-3025
PDSA-1525
PDSA-3025
PDSA-3025-AR
PDSA-5025
PDSA-5025-AR
Rated load
30Kg
15Kg
30Kg
30Kg
50Kg
50Kg
Load direction
Compression and Stretching
Mounting
Side embedded-fixing
Supply voltage
DC 5V/min ~
DC 10V/max
DC 5V(standard value)
Connection wire
7.5M x 4C Isolated-cable
Continuous accuracy
0.5%
Temperature coefficient
0.5% / 10K
Normal characteristic
value
1mv/V
Lateral axial force
Rated Load (F)
Bearing bore diameter
∮ 25mm
Mechanical limit
2.5 F
Protection class
IP 54
Operation conditions
Ambient temperature：-10～60℃ Vibration：2m/s or less
